How to Build Your Own Kitchen Cabinets Wooden Valance
Build your own kitchen cabinets – First to build your own kitchen cabinets, measure the distance between the cabinets which will put the valance. Cut a piece of 1- by 4-inch plywood to this length. Draw or trace a pattern on the plywood to the bottom edge of the skirt; scallops. Patterns and templates can be purchased in stores or home improvement downloaded online. Hold the wood on a workbench. Cut the pattern out using a jigsaw and router. Sand all surfaces valance with sandpaper middle grade, then sand again with fine sandpaper grade.
Cut two 2-inch squares of any piece of plywood to spare; they act as tabs that can be used to set the border to the build your own kitchen cabinets.Glue a tab on each side of the back of the valance. The tabs must be flush with the edge of the skirt so that the entire unit can be slid into the cavity between the cabinets. Slide the border into the cavity to ensure that adjustment. Stick the tape to the border with nails.
Apply the paint or stain valance if you wish. If you paint the border, apply a primer first. Once the paint or stain is dry, seal the polyurethane or lacquer finish. Install the border between build your own kitchen cabinets.